filtration pressure
英 [fɪlˈtreɪʃn ˈpreʃə(r)]
美 [fɪlˈtreɪʃn ˈpreʃər]
网络 过滤压; 滤过压
双语例句
- The Experimental Research on the Multi-stage Filtration Flow under Pressure Variation in the Series of Dynamic Rotary Vane Press Filter
旋转压滤机系列压力下各级间过滤速率的试验研究 - Effect of the different size of conjunctival flap in the shape of filtration bleb and intraocular pressure after trabeculectomy
结膜瓣大小对小梁切除术后滤过泡形态及眼压的影响 - In patients with preiously impaired left-cardiac function, both mechanisms hae the potential for increasing central blood olume and eentually lung filtration pressure.
对曾有左心功能损害的病人，两种机制都可能增加中心血容量并且最终增加肺滤过压。 - During the process of normal filtration, with the system pressure of the unfiltered media, the filtering bag also turns into a multi-valvular sectional cylindrical empty cavity.
正常过滤时在系统未滤介质压力的作用下，滤袋也形成一个多瓣形截面的柱形空腔。 - Micropore filtration under constant driving pressure is a powerful tool for assessing the RBC deformability.
等压微孔过滤法是测定红细胞变形性的重要手段。 - The bristle assemblies give serous fluid momentum step by step to form a rotary flow and to yield filtration pressure.
针轮由小及大逐渐向浆液传递动量，启动旋流，产生离心过滤压力。 - Treatment of low temperature and turbidity water by direct filtration with low pressure membrane
低压膜直接过滤处理低温低浊水性能研究 - The effect of operating parameters, such as filtration pressure, influent water flux and influent water turbidity on membrane flux is also investigated.
研究了操作压差、进水流量、进水浊度等条件对膜通量的影响，确定了合适的操作条件。 - Study on Resistance Model of Deep Bed Filtration at Constant Pressure
恒压操作下深层过滤阻力模型的研究 - Chamber Type Diaphragm Filter Press, which was invented in mid-20~ th century, characterizes high filtration pressure, large filtration area, low moisture content of filter cake, good anti-corrosion ability and economical operation cost.
厢式隔膜压滤机是20世纪中期发展起来的，其特点是过滤压力高，单机过滤面积大，滤饼含液量低，抗腐蚀性好，运转费用低。 - At the same time, factors such as filtration pressure, density of the liquid, particle distribution and temperatures which affect filtration properties are analysed.
同时，试验分析了过滤压力、悬浮液质量分数、粒度分布及温度等因素对过滤性能的影响。 - Recent innovations in filter media technologies focusing on filters for commercial and residential HVAC, portable air cleaners and vacuum cleaners were discussed. Utilization of this filter media technology allows for achieving MERV 16 level filtration at pressure drop lower than that of MERV 10 filters.
论述了关于商用和住宅HVAC、便携式空气净化器和真空吸尘器的最新过滤介质创新技术，利用该技术可达到MERV16过滤水平而压降低于MERV10过滤器。 - The way to gradually raise filtration pressure was adopted to keep a certain filtration speed.
为了保持一定的过滤速度，逐渐升高过滤压力。 - In practice, It is the key point for evaluation of bag filter's performance that how to resolve contradictory between the high filtration efficiency and high pressure drop and how to optimize the construction of bag filter.
实际运行中，如何解决高过滤效率往往伴随着高过滤阻力这一矛盾，对袋式除尘器进行结构和运行优化，以及优化选择合理的过滤介质，是改善袋式除尘器过滤性能的关键。 - Analysis of the Filtration Pressure in the Dynamic Filtration with a Rotating Cylinder Filter Media
旋管过滤中过滤压差的计算与试验研究 - Under non-stationary filtration condition, firstly the study about the effect of particle concentration, filtration velocity and filtration time on pressure drop was taken.
含尘滤料过滤阶段，测试了入口粉尘浓度、过滤速度等对过滤压力损失的影响。 - Sludge was compressed during filtration process, and resistance of sludge was increased with the increase in filtration pressure, the compressibility index was obtained as ( 0.807? 8).
污泥沉积层存在压密过程，这一过程中的污泥比阻随压力增大而增大，并得到处理市政污水的污泥压密指数为0.8078； - Filtration pressure of the concrete gravity dams
混凝土重力坝的渗透压力 - Filtration pressure should not be too high because of the high compressibility of the filtering cake.
形成的滤饼具有高可压缩性，因此过滤压力不宜过高。 - The effect of operating parameters, such as filtration pressure, crossflow velocity on membrane flux was investigated.
研究了操作压差、流速等条件对膜通量的影响； - Enhancing inner mud cake strength can significantly increase the pressure-bearing ability of core, and obviously improve the filtration pressure and strengthen fracture pressure gradient, which can enlarge the safe density window.
并能增强内泥饼封堵强度，从而达到提高岩心承压能力、漏失压力和破裂压力梯度，扩大安全密度窗口的目的。 - Previous theoretical models of micropore filtration under constant driving pressure did not take into account the filter clogging phenomenon which influences the filtration significantly and embodies important information on RBC deformability.
以往关于红细胞悬浮液等压微孔过滤的理论模型，没有考虑对过滤有显著影响并蕴含重要信息的滤膜堵塞现象，而且都存在一些问题。 - Mathematical model was established and applied to analyze the operation performance of fixed and moved bed filtration process. This mathematical model consists of filtration media and waste water mass balance equations, filtration kinetics equation and pressure loss equation of filter bed.
通过建立数学模型对污水固定床和移动床过滤过程运行特性进行了模拟分析，该模型包括滤料和污水质量衡算方程、滤层过滤动力学方程和滤层压降计算方程。 - It is reported that a vacuum filtration suction process is suitable for preparation of ceramic filter films. The uniform transition layer and separation layer of the ceramic fibers are obtained by controlling the concentration of the ceramic slurry, filtration suction pressure and time.
研究表明，真空抽滤法是制备陶瓷纤维膜较可行的成型工艺，通过合理控制陶瓷纤维料浆的浓度、成型时抽滤压力及抽滤时间可以获得均匀的陶瓷纤维过渡层和分离膜层。 - The result showed: the membrane fouling in initial time mainly caused by membrane pore plugging, and then sedimentary layer gradually formed and controlled membrane filtration pressure.
实验结果表明：膜污染在系统运行初期以膜孔的堵塞为主要污染，之后膜面沉积层的形成控制膜的过滤压差。 - In terms of granular layer filtration mechanism, size distributions of dust particles and experimental results, impact of filtration speed on filtration performance is amended. Formulae involving filtration efficiency and bed pressure drop are deduced.
根据颗粒层过滤机理、灰尘颗粒粒径分布的特点和实验结果，修正了过滤速度对颗粒层过滤性能的影响，得出了颗粒层过滤效率和床层压降表达式。 - Electret filters are mainly used to remove micron and submicron particles. Its salient character is of high filtration efficiency and low pressure drop.
驻极体过滤器主要被用来除去微米，亚微米级小颗粒，较高的过滤效率，较低的过滤阻力是它的显著特点。 - The PVA concentration, filtration pressure and filtration time on the BC/ PVA blend composite membrane filtration of bovine serum albumin were studied.
研究了PVA含量、过滤压力和过滤时间对BC/PVA共混复合膜过滤牛血清蛋白的影响。 - With increasing the filtration suction pressure, the thickness of the films increases, while the porosity and pore size decrease.
另外，随着成型时抽滤压力的增大，相同条件下形成膜层厚度增大，但膜材料孔径、气孔率随之减小，而成型时抽滤时间只是对膜层厚度有一定的影响。